Head Shop Services
| Install hard seats, exhaust |
$95.00 |
Machine intake manifold surface |
$95.00 |
| Install guides |
$125.00 |
Cut for screw in studs & guide plates inline |
$110.00 |
| Surface Heads |
$45.00 |
Cut for screw in studs & guide plates canted |
$140.00 |
| Radius seat Valve Job |
$120.00 |
Replace seats in Alumin. heads (labor only) |
from $160.00 |
| Pressure check head, each |
$40.00 |
Angle mill heads .040 |
$120.00 |
| Vaccum check heads, pair |
$15.00 |
Angle mill heads .060 |
$140.00 |
| Set up springs & assemble |
$45.00 |
Angle mill heads .080 |
$175.00 |
| Clean heads, pair |
$20.00 |
Angle mill heads .125 |
$185.00 |
| Mag heads, pair |
$20.00 |
(includes redrilling, head bolt holes & dowels) |
|
| O-Ring heads for lock wire |
$70.00 |
Stock spec valve jobs |
$100.00 |
| Flow test on SuperFlow 600 |
$50.00 |
CC chamber each head |
$40.00 |
Machine Shop Services
| Bore and hone block |
$96.00 |
Screen lifter valley and drain back |
$50.00 |
| With torque plate |
$40.00 |
Machine and install dry sleeve |
$60.00+cost of sleeve |
| Surface block |
$60.00 |
Square deck |
$85.00 |
| Clean block |
$35.00 |
Install cam bearings |
$25.00 |
| Mag block |
$21.00 |
Resize rods (big end) |
$7.75 each |
| Deck block per pass .005 |
$10.00 |
Float and bush small end of rods |
$6.50 each |
| Install 4 bolt caps & line bore (most) |
$350.00 |
Fly cut pistons (int.&exh. pocket only) |
$90.00 |
| Shot peen rods |
$35.00 |
Stroker clearancing |
$120.00 |
| Install main studs |
$65.00 |
Main Girdle installed, includes girdle |
$200.00 |
| Install oil restrictors |
$50.00 |
Paint lifter calley and prep |
$35.00 |
| Polish beams on con rods |
$70.00 |
Cut O-ring grooves V-8 |
$65.00 |
| O-Ring block |
$125.00 |
Install main bearing spacers |
$300.00 |
| Line hone |
$100.00 |
(351W only bearings included & line bore) |
|
| Line bore |
$150.00 |
|
|